| General Information |
|
| General Catalogue |
|
| At a glance |
|
|
|
| TRUBOMAT GS 3, Turbidity controller |
General Catalogue 410-01 |
TRUBOMAT GS 3, Turbidity controller
- ON/OFF turbidity Controller
- No effect of day light
- Output relay
- Adjustable delay
- Dysfunction indicator |
The TRUBOMAT GS3 is designed to be used with our immersion probe CP1 or our turbidity armatures GA1 ... GA5. It provides a contact signal as soon as the turbidity reaches the preset value.
A complete system compares continuously the measured value with the preset value; it is not pre-calibrated in factory but calibrated on site by end-user. The technician on site configures the instrument using samples to calibrate the limit for switching the output between correct turbid sample and overpass turbidity value.
Most of all products can be monitored, even with high load, small or big particles.
A complete turbidity control system includes:
1 turbidity controller TRUBOMAT GS3
+ 1 immersion probe CP1 (built in emitter and receiver)
+
Or
1 turbidity controller TRUBOMAT GS3
+ 1 armature GA ...1 /...2/ ... 5/ ...11 (DN 15 to DN 200) for in-line measurement / by-pass (emitter TT-GS and receiver TR-GS included)
- Control on phase separation milk/water
- Diaphragm filtration efficiency
- Survey on separation, centrifugation... process
- Pollution control
The turbidity system works as a limit monitor. Turbidity measurement is based upon absorption, i.e. it responds to loss of light caused by turbidity in the liquid medium.
The emitter TT-GS send the IR beam (940 nm pulsated 8 kHz) through the fluid to the receiver TR-GS. The variations due to the turbidity are fully used by the TRUBOMAT to detect the over passing preset value.
To avoid false alarms due to air bubbles or accidental excess of turbidity, switching delays are adjustable from 0 to 10 seconds (increasing and decreasing turbidity).
The armature GA... are convenient even for fluids with a turbidity over 3000 FAU/ FNU / FTU. Emitter and receiver are partially blinded with a washer (0.5 mm hole) that can be deposit to allow high turbidity detection.
|
Turbidity controller
TRUBOMAT GS 3 |
General Catalogue
410-01 |
|
|